2 HP Units for every lift
Electric Hydraulic units for your 2 posts lifts and 4 post vehicle hoists, parking systems lifts, dock lifts, handling tables, scissors lifts or other lifts and applications that demand extreme quality and performance.
Why settle for anything less. RHINO Power warranties through our resellers and from the factory direct at no additional cost. Other brands offer a one-year warranty that does not include prepaid freight both directions.
-
2.1 Gallons per Minute flow rate
We aren’t typical and typical brands have a lower flow rate because their electric motor does not produce enough torque over extended time. Not ours!
-
208-230-volt single phase 60 Hz
Our unit operates in varied voltages. Most motors will not operate in the 208 voltage systems…they are only rated at 220 volts. Our unit can be used Globally.
-
2 hp 3450 rpm motor (3.5 hp motor torque equivalent)
Our high-quality motor will not get hot and decrease speed and torque. Built with super heavy-duty armatures and extra motor windings (additional silver metal included in the wires and connections) eliminate decreased torque. RHINO units maintain constant torque through the lifting process because we generate less heat.
-
3.6-gallon opaque high-density plastic tank
Allows you to see the fluid levels. No guessing.
-
Pressure settings available from 2300 PSI to 3500 PSI
No need to stock multiple units of diffent PRV. We offer adjustable PRV. Why pay more when you don’t have to.
-
Extra-large junction box for easy installation
Extra-large junction box makes it easier preparing electrical connections than traditional smaller cramped boxes. Eliminating electrical shorts.
-
Extra heavy-duty Honeywell BE22Q1-AL off/on switch. This is an extra cost that no other power unit manufacturer will spend the extra money on. We insist!
We know the number one complaint for all power units is on/off switch failure. To eliminate this we selected and tested the BE22Q1AL and had zero warranty claims in 4 years!
-
Pump outlet can be on either side of unit to allow pressure line to be mounted in the same position your current power unit
We offer dual outputs in our standard models. Others don’t.
-
3/8″ pipe thread port and internal pipe for lifts that have a cylinder vent return to tank
RHINO is the only power unit in production that allows the return line flow from non-pressured return lines. AND internal lines can be used for slave side hydraulic functions as may be required by an older lift manufacturer.
-
Suction tube micro screen filter included
For longer pump/motor life our suction pick up tube has a fine micro-screen to prevent any debris from entering the pump.
